Which bits are likely to get broken when being resprayed

[leersv]

Hello,
I am planning to have the car resprayed in May and would like to know which bits are likely to get broken or need replacing.
Car is a 92 FD
I know the beltline trim (below window on door) are pretty shabby, but there must be other bits that are likely to be brittle that I can organise now and have ready for then it goes in.
Any part numbers would be great as well to save me hunting them down later.
Finally should I get parts from RHD japan or use the local Mazda garage?

Thanks
Lee

 

[Rmcyes]

I've gotten new front and rear window seals and all associated bits from my local mazda dealer.

I've replaced the wings and fitted a 99spec front bumper along with new headlight assemblys with no issues breaking anything.

Everything bolt off and on no problem.

 

[Mid Night FD]

Just had a respray on mine, only issues i had were the beltline strips on doors and the fact you have to cut the front and rear screen finishers out if removing glass ( I ordered all new from mazda). As Rmcyes said everything is quite easy bolt on and off, its always the plastic trims and clips that can be a pain.

 

[leersv]

Thanks for the responses.
I don't suppose you have the part numbers for the F + R window seals please?
Lee

 

[Mid Night FD]

Look up Mould window Fr (Front FD0150601B) and Mould RR window (Rear FD01506G0B) , this was on my invoice from mazda. I've yet to fit but they look right and had them out the packaging for a closer look. Glass is bonded in first followed by these finishing moulds, the door beltline strips are on there too, hope this helps

 

[leersv]

Excellent, thanks. That is a great help.
Now to get on to mazda
Lee