How to remove the twins?

[JoeLanger]

The last time i put my rebuilt twins back on i used titanium nuts, have never tried to take it off again and really hope i havent made a really bad decision.................

I used Ti nuts the first time and they was fine, on my single I used normal steel, used 316 spring washers in both cases

 

[Wolfie1]

I used Ti nuts the first time and they was fine, on my single I used normal steel, used 316 spring washers in both cases

Well thats reassuring!

 

[Ceylon]

Don't need to touch the engine mounts or the steering column if the downpipe is oem. They "just" about wriggle out. As said, soak the lot in penetrating fluid and it should go ok.

 

[Daston]

Don't need to touch the engine mounts or the steering column if the downpipe is oem. They "just" about wriggle out. As said, soak the lot in penetrating fluid and it should go ok.

Oh thats good news been squirting everything in plusgas each evening until the weather improves

 

[Cyman]

Oh thats good news been squirting everything in plusgas each evening until the weather improves

You dont need to but for the sake of a couple of bolts on the steering column it's worth it for the extra bit of space just mark it first. And although you dont need to undo the one engine mount again for one nut and a jack this also can make it easier especially if you have some tight bolts.

 

[a.tapos]

I know its been said but i like to take it off its engine mounts,makes the job 50% easier